I think we already spoke but just to update the thread, no alarms were shown, and it hasn't happened since the end of april. thanks

Update to RS485 firmware is Z02T13 fixed the issue. Thank you very much for your help.

@eg4eric I was on GRID power (AC First setting). Manual says AC BYPASS is 50A.

@eg4eric I have TWO inverters in parallel, shouldn't the limit be 6000 per phase ?

@chill633This is not supported at the moment. It is still a work in progress. When it is available, we will announce it and let you know.

@chill633 Thanks for the graphic. Here is what I see on the web monitor page. I connected to the FlexBOSS 21 load port after reading several comments ...

Thank you for the link. The site doesn't have a drop down for the 280ah indoor under batteries, so I used searched. The search firmware version list...

@usmcrtr I believe the correct (latest) RS485 firmware is Z02T13 ... this corrected the problem(s) with the battery system settings on the monitor t...

If you land here, the easy way around this is to remove the dongle from the station, delete the station, and recreate the station at the same time as ...

That document is old. 🙂 Yes, it'll work, but no, it won't report incoming AC-couple properly. If you have a GridBoss, all AC Couple is supposed to g...

Any movement on this? Seems like a pretty basic function to me.

@usmcrtrEnsure that you have the Inverter's Lithium brand to 1 instead of 0. If you share some pictures of how everything is connected that would be a...

If your generator is big enough, it will power the loads and charge batteries depending on how much Power your panels are producing. However, if it's ...

Yes, you can! Just ensure you have Shared Battery Disabled