EG4 Community Forum

Anonymous
Joined: November 21, 2026 9:35 am
Topics: 7 / Replies: 19
Reply
RE: 12000XP Momentary full outages

@dannybeardsley Have you tried starting your AC units with no other loads or very minimal loads to see if you experience the same issue?This will help...

1 month ago
Forum
Reply
RE: Flexboss 18 with 314AH

What is the VOC for each panel?Do you have the link for the solar panels?  

1 month ago
Reply
RE: Mini split running on 6000XP throwing pressure fault

Is your inverter connected to the internet through the Wi-Fi dongle?If so, I can take a look at your system remotely and see if I can find what may be...

1 month ago
Forum
Reply
RE: 18kPV Smart Load Configuration Best Practices

Just a word of note. I have an 18KPV and was using the Gen port for Smart Load also. It was working properly until I installed a GridBoss later, at wh...

1 month ago
Forum
Reply
1 month ago
Reply
RE: Fan Noise Suppression

Are you referring to the 12000XP or the 12kPV?The fans can be a bit loud but only when batteries are charging at a high wattage or when loads are pull...

1 month ago
Forum
Reply
RE: How to install CT sensors in combo service entrances?

While this is not an official recommendation from EG4, Rogowski CTs can be compatible with the WattNode meter. However, you would need an auxiliary RG...

1 month ago
Forum
Reply
RE: EG4 6000XP – Recurring Fault 17, MPPT Failure, Ghost PV Voltage – Firmware Updated

@nizarsolarThank you for all the information and pictures you provided! Has EG4 identified a known hardware failure involving the 6000XP MPPT boar...

1 month ago
Forum
Reply
RE: 12000XP Momentary full outages

@eg4eric it's 3.5 ton (what a weird unit) and consumes about 4kw. There have been no alarms and no events in the event log when I experience the pro...

1 month ago
Forum
Page 9 / 437