We apologize for the delay. A new firmware has been released for both indoor and outdoor WallMount Batteries that resolves the display error on the EG...

@eg4eric I was able to visit the remote system. Unfortunately I only had enough time to bring the battery up to SAOC of 20%. The inverter was still ...

@eg4eric I'm using voltage...no comms. I've got the generator figured out now, thanks.

Certainly, thank you so much! I don't think I have a Ticket #, have simply been emailing back and forth with their tech support? or maybe I'm missing ...

Thanks that's what I suspected. I have 4 x 100Ah LifeP04 but that's not enough to power everything (hence the critical load panel) so now I am think...

@eg4eric More while we're on battery. I'll switch off Seamless EPS and see if that makes a difference.

@johnaand Understood! I wasn’t able to review any data because your inverter doesn’t appear to be connected to the internet. Based on what you describ...

@fkitzmann Can you please share a video of what you are seeing?You should be able to hold the button for 5 seconds to switch between Wi-Fi and Etherne...

@cnmmike Once the battery reaches the Discharge Cut-off voltage/percentage, the inverter stops actively discharging the battery and goes into standb...

@rpeatfieldFrom the way you described it, it sounds like the generator would only power the backup loads.

@harrisranch You will need to change the time is 3 different places. Configuration > Station > Edit > Set correct Time zone Config...