@swigleyThank you for bringing this to our attention. It looks like it was just a typo in the file name, but I’ll report it so it can be corrected. If...

Thank you for sharing that!It appears to be a small bug. I'm not exactly sure what the other voltage represents. It seems like it could be each invert...

It should automatically detect it; however you can manually set it to 120/208 through the application settings on the Monitoring website, or you can u...

You can set the inverter to Lead acid, which will charge and discharge the battery by voltage. Do you know if the battery BMs has any protocols from t...

It depends on the distributor from whom you purchased your system. Each distributor has their own code. Who is your distributor?You can use EG4LUX01 f...

This is actually the first time I’ve heard of using a signal cord in this type of setup. I’m not sure if it would work or how it would work.

As long as the generator settings are configured with the correct start and stop SOC values, the FlexBoss will automatically switch to using the gener...

Are you looking for an installer?

You can enable AC Charging, which allows the batteries to charge from the grid up to the specific percentage you set.

@wardo5757 Thank you!

@wardo5757 Thank you, I don't think I have seen this before. I'll go ahead and report this bug. Is this happening every time you open the app?

That is correct. Thank you!

Do you know which version of the app you're using? You can find it at the very bottom of the login screen.

@solar_pergola It depends, NEC 2023 does require RSD for ESS under certain conditions, primarily for firefighter safety. However, enforcement depends ...

As of now, you will need 2 generators. 1 for each Gridboss. I don't believe it is possible for 2 Gridboss' to control 1 generator.