I can definitely submit a request to our team for this.

Hallo Eric, Thanks for reply. Actually I wanted to use dry port to trigger the external relay switch based on the SoC of the battery. Is there any...

@eg4eric Thanks a bunch! I will try this out.

Do you have Solar panels with your system?1E is a part of a different firmware, so you have 2 different firmwares installed. To have the correct firmw...

1) You can set the System Charge SOC Limit(%) to 80%, but then will not allow the batteries to charge to 100% at all. It will always charge to 80% (Th...

There is not. Do you know how many you installed and VOC of the panels?How many volts are you getting as of now per string?

If you are wanting for the generator to start and stop according to the charging parameters, you will need to connect to NO1 and COM1.

That is strange. Hopefully someone from EG4 will chime in.

solar only .

I apologize for the confusion. The server was fully up and running after about 10 min after I posted. Please let me know if you have any other connect...

Are you using Solar, AC or both to power it?

@krzysiek_kta Please let me know if it stops or if you continue to have issues!

Thanks, I found that table in the Manual, Yet after some tests it seems doesn't reflect the dry contact behavior. I have connected two tes...

The only difference I see is if you have grid or not. With Grid the Gen contacts behave a little differently as it won't close the gen contacts when...