EG4 Community Forum

jckemp3
@jckemp3
Eminent Member
Joined: December 26, 2024 5:24 am
Last seen: September 5, 2026 11:34 pm
Topics: 1 / Replies: 26
Reply
RE: Tracking Grid Usage

@solar2025 I am in the exact same boat as you , no sell back with PG&E. I have seen few spikes here and there on the monitor that looks like it pu...

1 week ago
Forum
Reply
RE: Tracking Grid Usage

@solar2025 out of curiosity , is there reason you choose to run in off-grid mode say verses self consumption ?    

2 weeks ago
Forum
Reply
RE: Tracking Grid Usage

@solar2025 I do not think in off-grid mode there is a way to see the grid tie loads, someone from EG4 will have to confirm if that is correct. sorr...

3 weeks ago
Forum
Reply
RE: Tracking Grid Usage

@solar2025 Are your CT's on the breaker feed to your backup panel or feed from meter to panel ?

3 weeks ago
Forum
Reply
RE: Tracking Grid Usage

@solar2025 Sorry I tried to edit my post but I was not allowed too. After rereading your question here is my thought Put your system in offgrid mode...

3 weeks ago
Forum
Reply
RE: Tracking Grid Usage

@solar2025 I think "consumption" is the value you are looking for from the monitor website/software . As long as your CT's are above the main breaker ...

3 weeks ago
Forum
Reply
RE: At the end of my first full day on 2nd wall mount battery; Some things don't look right on the desktop app.

@minidude if you are using Volt for discharge control , it ignores SOC. If you are using SOC then it combines the 2 SOC, then divides the 2 . So it wo...

3 weeks ago
Forum
Reply
RE: Can EG4 provide feedback about flickering on the 18Kpv?

I would make sure you don't have a shared neutral somewhere in a switch or half-hot outlet. I had the same issue until I found one in a half-hot/sw...

4 weeks ago
Forum
Reply
RE: At the end of my first full day on 2nd wall mount battery; Some things don't look right on the desktop app.

@minidude I have a similar condition with my few batteries SOC being different. I switched to Lithium battery- Volt charge and discharge control . ...

4 weeks ago
Forum
Reply
RE: Error W009 - fan stuck

  Allen ,   I cannot help with the problem you are having , but I did do an RMA with EG4. There is a phone number on the sticker on s...

3 months ago
Forum
Reply
3 months ago
Forum
Reply
RE: Peak shaving settings being ignored

@gtsquires I am on the newest 2727 firmware and lcd screen firmware. I believe you were on 2525 and a much older screen firmware. Dont know if tha...

5 months ago
Reply
RE: Peak shaving settings being ignored

@gtsquires I have the 12kPV version . I have had a fairly smooth experience with my inverter, most issues I have created in my learning . This ...

5 months ago
Reply
RE: Peak shaving settings being ignored

Settings all look correct , I would try a restart of the inverter if you haven't already . Another work around I just found is in working mode you ...

5 months ago
Reply
RE: EG4_FAAB-2727 (Most Recent Firmware)

In the picture below you can see that at 11:00 Grid started to cover consumption. Solar went all to charging battery. This is during my AC Charge time...

5 months ago
Forum
Page 1 / 2