Updated the Flexboss to the latest firmware the other day after another "trip" with no errors logged. Reset the whole system again and we were good fo...

@holymaniac I am getting with Spencer on this and reviewing the ticket to determine what may be causing the issue.

It might be caused by the settings on the GridBoss. If you share your inverter's serial number, I can take a look at the settings for you, or you can ...

Granted, but the GENERAC "Exercise" function is provided to keep the motor lubricated and demonstrate start-up. Load testing has been done by actual o...

@subguy What's missing from the generator auto-exercise is that it doesn't failover to generator for power, so generator starts but without any load. ...

@eg4eric Thanks kindly! The main issue still unresolved is that the watts coming from solar panels climbs up as expected to around 2500 at noon and t...

I just wanted to share a solution that gives me lan access to the dongle while still connected to my home wifi. I'm running a glinet router that supp...

@yooperjay Thanks for the update. I too have been trying to figure out how to do the 80%DOD since I am not here all the time and don't want the Gen ...

@joel-brodeur I reverted the firmware back ... it mostly solved the problem of it bouncing between 99%-100%. I no longer see the bouncing but some...

@yooperjay Have you seen any improvement or heard anything on this? I called my vendor (Signature Solar) and they said it was because my loads were...

Our tech support team can also update the firmware battery remotely for you. You can reach our tech support team by email at support@eg4electronics....