EG4 Community Forum

Anonymous
Joined: November 21, 2026 11:40 am
Topics: 7 / Replies: 19
Reply
RE: EG4 14.3 kWh Indoor Wallmount Batteries – Zero Volts at Terminals on Startup

@eg4eric I attached the only photos I have handy of my battery-inverter connections, but I don't think they will help much. Pretty conventional stu...

3 months ago
Forum
Reply
RE: Periodic Re-Balancing or Re-Calibration multi-battery installation?

Hi Eric, Thank you for your rapid response! Based on your response, I think my ideal scenario would be to keep the system in backup mode and then ...

3 months ago
Forum
Reply
RE: TIme is wrong (DST)

Thank you for bringing this to our attention, and we apologize for any confusion regarding the Daylight Savings Time feature. The DST feature was de...

3 months ago
Forum
Reply
RE: EG4 14.3 kWh Indoor Wallmount Batteries – Zero Volts at Terminals on Startup

@jxnhrprAre you able to share some pictures of the connections on the batteries at the inverter and on the batteries? I can begin to make a ticket and...

3 months ago
Forum
Reply
RE: EG4 14.3 kWh Indoor Wallmount Batteries – Zero Volts at Terminals on Startup

@eg4eric Yes, I tried to reset them to ID=1 and ID=2, but I think the steps I followed weren't quite correct. I was getting 0V at the inverter's BA...

3 months ago
Forum
Reply
RE: TIme is wrong (DST)

I am posting this again because no other communication has been effective. The Daylight Savings Time bug was identified (as can be seen in this post...

3 months ago
Forum
Reply
RE: BUG - need a fix for open loop charge curve for Lithium batteries

@eg4eric , it would be even better if the Beta firmware could be promoted to "latest" so we could all do our own ?! I installed another 12000xp at a c...

3 months ago
Forum
Reply
RE: battery cable terminations for finely stranded 2/0 cable.

@bobcThe Flexboss21 does have Mechanical Terminals

3 months ago
Forum
Reply
RE: EG4 14.3 kWh Indoor Wallmount Batteries – Zero Volts at Terminals on Startup

@jxnhrprThe batteries need to be set to ID 1 and ID2 and have the BMS reset. Just pushing the power button off then back on. Are you getting voltage o...

3 months ago
Forum
Reply
RE: Periodic Re-Balancing or Re-Calibration multi-battery installation?

@anothereg4userGood afternoon! 1. Is periodic re-balancing/re-calibration necessary or recommended for my system/configuration?We recommend an 80% D...

3 months ago
Forum
Reply
RE: BUG - need a fix for open loop charge curve for Lithium batteries

@heshy Thank you for your input! I agree with you, and I will be sharing this with our team. If necessary, I can also install the beta firmware on you...

3 months ago
Forum
Reply
RE: Tracking Grid Usage

@solar2025If you have the Ct's located between the meter and the main panel, you will be getting the readings of any power coming and going to the gri...

3 months ago
Forum
Reply
RE: My Solar Power Setup

That’s a seriously capable setup, especially the jump to around 60 kWh of storage. The combination of ground-mounted bifacial panels and that much bat...

3 months ago
Page 20 / 437