Which webpage are you referring to?Were you looking for a specific product? I could possibly help.

I could look at the battery with ID 64, but not the other 2. The manual said to connect to the RS485 RJ45 jack, so that is what I did. I assume it w...

Correct! It would be the same as they use very similar BMS. The Lifepower4-V1 use a different BMS, that is why they use BMS TEST.Please let me know if...

How many batteries do you have in total? Also, how do you have the batteries connected? Are you using bus bars?

You’ll need at least 140V for the MPPTs to begin operating and charging the batteries. Do you know if the voltage has gone above that threshold and ...

Unfortunately, the 12kPV wasn't designed to have the breakers replaced with smaller ones. You can limit the amount of current used from the generator ...

I have the same issue with the correct time not sticking with my GridBoss, firmware version IAAB-1300

Hmm. Actually, this is worse than originally stated. I'm not sure what is wrong with the downloaded file, but here are the steps you can follow to ...

No solar yet (it is trickling in thru an old PWM controller, OCV is too low to use the 6000, we need to add another panel there) Gen Boost is NOT en...

Do you have solar connected to it?Just to confirm, you said you don't have GEN boost enabled, correct?

@eg4eric version 1.5.4 I logged out, removed the app, rebooted the phone, reinstalled and logged in, same offline message. I'm using a Pixel 7 Pro...

So with the V2, I use the BMS Tools, not the BMS Test, and my RJ45 should be plugged into Battery Comm. I will give it a shot after changing battery ...

@thomaspugmail-com Great! If you have any other questions or run into any issues, feel free to reach out!