EG4 Community Forum

Anonymous
Joined: November 21, 2026 12:08 pm
Topics: 7 / Replies: 19
Reply
RE: EG4 12000XP using actual lead acid batteries, Very low charge rate.

Well can't go back and edit that, the AH total is of course 1284. Regardless, I no longer have an issue.

3 months ago
Forum
Reply
RE: EG4 14.3 kWh Indoor Wallmount Batteries – Zero Volts at Terminals on Startup

@frugal-farmer. My EG4 batteries usually communicate fine with my EG4 6000XP inverter, and I have been operating in closed-loop communications mode. I...

3 months ago
Forum
Reply
RE: EG4 12000XP using actual lead acid batteries, Very low charge rate.

ISSUE RESOLVED!!I had been reading the AH rating on the battery, but not looking really closely. Each battery has a 428AH rating for 20hrs. I had used...

3 months ago
Forum
Topic
Reply
RE: At the end of my first full day on 2nd wall mount battery; Some things don't look right on the desktop app.

@jckemp3 I’m using VDC. The cut off is set to 50. But for some reason, due to the fact that it takes the average VDC, my batteries go really low. Toda...

3 months ago
Forum
Reply
RE: EG4 14.3 kWh Indoor Wallmount Batteries – Zero Volts at Terminals on Startup

SS informed me I will need to put the parameter listing as "lead/acid" batteries since I am not using lead/acid but they are Lithium from an alternate...

3 months ago
Forum
Reply
RE: At the end of my first full day on 2nd wall mount battery; Some things don't look right on the desktop app.

@minidude if you are using Volt for discharge control , it ignores SOC. If you are using SOC then it combines the 2 SOC, then divides the 2 . So it wo...

3 months ago
Forum
Reply
RE: Can EG4 provide feedback about flickering on the 18Kpv?

I have 6000xp and have some flickering too. The inverter was RMA replaced and status is the same. Yet I managed to identify the culprits - the 'dirty'...

3 months ago
Forum
Reply
RE: 18kpv mislabeled in monitoring as 12k

Is there anything else you need?

3 months ago
Topic
Replies: 1
Views: 588
Reply
RE: Frequent high cell voltage on new installation

Problem has been resolved by reprogramming the system to use the Victron SmartShunt battery monitor instead of the EG4-LL Can-bus monitor. While I di...

3 months ago
Forum
Reply
RE: EG4 Monitoring System

@EG4eric, you requested updates when we see the servers offline. Today, Wednesday Aug-19-2026 from 18:02 - 22:04 PDT the server was unavailable. T...

3 months ago
Reply
RE: Daylight Savings Time

@eg4eric You mentioned submitting this 2 year-old-ongoing-issue to engineering 5 months ago. What is their perspective? Is DST to be addressed? Hopi...

3 months ago
Forum
Page 22 / 437