@cmart1220 I apologize I missed this! If you share your inverter or Gridboss serial number with me, I can look at the alarms and data to identify what...

@adamsonaire I don't believe this is currently possible, based on my understanding, but I'll double-check to confirm. There is a debug mode I can enab...

@eg4eric Has there been any moment on this? I would also like to change some of the trend configurations and the poll timing. I am a BMS design engine...

EG4 Takes Charge! It took me a while longer to get this next post together than I planned. Life has it's demands. Later on the 16th; about 2 hour...

Credit where credit is due! I have been advised by other members that I committed a major faux pas in my last post! It seems that in order for me ...

Leave a reply

Manual bypass switch was flipped on this time and required switching off before I could properly reset things. First few resets this go around didn't ...

Happened again today. E019 error registered in the event history. Would be great if someone was able to chime in with remediation steps. This is super...

@eg4eric Any updates?   Brgds   K

Not yet - but have some info: EG4 is re-skinned LUXPower electronics from China - the ports run CANbus and someone has reported successfully using a...

For anyone searching for the answer I figured it out myself, its for thier "EG4 BMS" app on the App Store, you can use this app to directly connect to...

  Not sure why no one here or email support has this answer but after lots of searching finally figured it out myself. The antennas are for the...