@ionstorm66 Another option to above is to use autotransformer 120/240V as the intermediary between the 120v Gen and the Inverter. e.g. Vic...

@krzysiek_kta - Yea, im not going to update mine until they specifically address the comms issue in the release notes of the firmware. I have comms dr...

An Update. After latest RS232 and RS485 BMS firmware update neither of my previous temporary solutions to make my system work in Closed Loop mode wo...

@clarktheshark I have reoccurring issues of 280Ah indoor batteries BMS loosing the comms with my 6000xp when in closed loop comms mode. I don't t...

Eric, Unfortunately when you logged into the inverter the display was not connected. I have since connected it and found that the display still was no...

@eg4eric ... 7 months later do you have any information about the wifi antennas, how they are supposed to be used and their purpose??   &n...

just occurred while charging batteries from grid. Same thing tho. batteries lose communication briefly, then it takes exactly 10 minutes to go back to...

Update: It appears that either my batteries have completed top balancing or there has been a change in the monitoring site. When I reach 100% I am...

Can anyone from EG4 comment here?

@walkerThe only way to ensure zero power is exported to the grid is to enable Off-Grid Mode. Keep in mind that when Off-Grid Mode is enabled, the inve...

@simply-efficient thats my understanding, the switch on the gridboss needs to be directly connected to the RSD port on the flexboss for it to work...t...

@offgriddd I did not connect those. There's not a jumper in the gridboss. I'll connect the flexboss ess in series with the gridboss. So the gr...

Yes, system is running, I updated each unit, then connected the comms cables between the gridboss and flexboss. Tested the ess switch connected to th...

Follow-up / clarification (please disregard my 85% example):Since posting I identified a SEPARATE issue with my battery's SOC gauge — the pack'sreport...

@rpeatfield I will send you a DM.